PICATINNY RAIL AND STICKER ADAPTORS
Picatinny Rail Adaptor
- A. Adaptor release handle
- B. Rail to the camera side
- C. PICATINNY tightening Screw Nut
- D. Rail to the Rifle Side

Sticker Adaptor
- A. Adaptor Handle
- B. Rail to the Camera side
- C. Adhesive Surface

Mount your camera with the PICATINNY adapter
- Open the adaptor screw nut and slide the Picatinny adaptor onto the rifle’s rails.
- When the adapter is placed, insert and close the screw nuts to lock the adapter in the desired location.
- Slide the camera into the adaptor rails.
- To remove the adapter from the camera rail, press the handle and pull the Camera out in the opposite direction.


Mount your camera with the sticker adapter
- Thoroughly clean the adhesive surface.
- Remove the protective paper from the adaptor adhesive area and attach the adhesive surface onto the object you wish to carry the adaptor on.
- Slide the rail of the camera onto the adaptor to the end of the slide.
- To remove the Camera from the adaptor, press the handle and pull the adapter in the opposite direction.

Guidelines for the sticker adaptor
- Follow these guidelines when attaching adhesive mounts to helmets, vehicles, and gear;
- Attach the mounts to smooth surfaces.
- Clean the designated surface with alcohol, but before that, it is recommended to check with the manufacturer's instructions.
- Firmly press the mount onto its place. Make sure the adhesive surface is in full contact with the designated surface.
- Only use on clean, dry surfaces. Wax, oil, dirt, or other debris will weaken the bond, and you could lose your camera.
- Attach mounts in dry room temperature conditions. Damp or cold or environment and surfaces will not allow optimal performance.